where and what wires go on the alternator on a 1965 ford f100

The alternator is an essential component of the electrical system of your 1965 Ford F100. But, do you know where and what wires go on the alternator? Knowing how to properly attach the wires correctly is important for the proper functioning of your vehicle’s electrical system.

The first wire that needs to be attached to the alternator is the positive output. This wire should be connected to the positive terminal on the back of the alternator. The other end should be connected to the starter solenoid. Next, attach the negative output wire to the negative terminal on the back of the alternator. This wire should be connected directly to the battery. Then, attach the voltage regulator wire to the voltage regulator terminal on the back of the alternator. Finally, connect the ignition switch wire to the terminal on the back of the alternator that is labeled “IGN.”

Attaching the wires to the alternator of your 1965 Ford F100 is a simple process. However, it is important that all the wires are attached correctly in order for the electrical system to work properly. Failure to properly attach the wires can lead to premature failure of the alternator or other components of the electrical system. If you are unsure of how to properly connect the wires, it is best to consult with a professional mechanic who is familiar with your vehicle.

Wires From Alternator To Voltage Regulator Ford Truck Enthusiasts Forums